See them here Here are the short promo videos for the blowers
A Lapping Wheel Maybe A Diamond Saw And a facet holder.
Yes and no. The bigger the terp pearls, the harder they are to spin. The more oils in the dish, the hard to spin. But with a good spinner carb cap, you can get them to spin with a normal inhale.
The reality is anything you put in your lungs other than clean air is bad for you. Now, if a tool is bad or not comes down to really how it is used. You could use a silicone dab tool, but if you get it to 1000 degrees, it might not be good. If the …
He does all the work cold. He cuts the glass, polishes the glass, and then uses an epoxy to “weld” the glass together.
They are made much like a small marble, but with larger prep, more heat and more glass. The blower uses a marble mold to keep it round as they make it.
Because the way a dome and nail worked required it to be very hot. With the new way of doing low temp dabs we have found there is a better way. Also, clean up of a banger is easier than with a dome and nail.
A SideKick V1 heats up about 30 seconds faster do to the 7 volts compared to the 3.5 volts in the V2. But the V2 gets 0-10 uses while the V1 gets about 3 uses per charge. Average heat up time is about 1-1.5 minutes
Because under 18 you just can not make your own decisions in life. This is the law
Yes, with a hole it helps the terp pearl spin with only the need for a marble. The bottom should not have any effect on the spinning of the terp pearls.